Pulsar Thermal Zeroing Targets

A pack of air activated thermal pads with paper targets for zeroing in thermal scopes. Supplied with 10x adhesive thermal targets, which measure 40mm in diameter, and 10x paper targets to use them with, which measure 30x30cm.

The pads take approximately 3-5 minutes to heat up and will remain hot for 10-20 minutes on cold surfaces depending on weather conditions.

Instructions:

The heat pack is air-activated, do not open the pad until you are ready to use it.

Open the packaging and take out the heat pad. Note! Do not cut or damage the heat pad while taking it out.

Remove the paper strip from the back side of the heat pad to expose the adhesive surface.

Stick the heat pad with the adhesive side to the center of the paper target marked with circle. Note! There is no need to shake the heat pad, it will warm itself up in 3-5 minutes.

Attach the paper target to the desired location.

Aim at the heated pad with a thermal imaging scope mounted on the firearm and optimize themal view, so that thermal pad is clearly visible.

Perform zeroing procedue as described in the user manual of your thermal imaging device. With the help of the round shape and small diameter of the pad, deviations of point of impact can be eliminated in just a few shots.